Makita PM7651H Original Instruction Manual page 20

Installing and removing the dispersion cover
(2)
To install the dispersion cover (1), mount the dispersion cover on the top nozzle (2)
(4)
so that its protrusion (3) is aligned with the notch (4) in the top nozzle.
(1)
(3)
Secure the dispersion cover by turning it fully clockwise.
To remove the dispersion cover, follow the above procedure in reverse.
Installing and removing the deflector (optional accessory)
The deflector (1) allows chemicals to be sprayed upward. This helps treatment for
(1)
low-growing plants and the underside of leaves of plants.
To install the deflector (1), mount the deflector on the top nozzle so that the "I" mark
(4)
(3) on it is aligned with the "I" mark (4) of the top nozzle (2).
Secure the deflector by turning it fully clockwise.
(2)
(3)
(1)
To remove the deflector, follow the above procedure in reverse.
Changing the nozzle to a small-amount-solution-discharge
nozzle (optional accessory)
When a small amount of solution needs to be sprayed, replace the nozzle cap with
another type of supplied nozzle cap with a small discharge hole.
To replace the nozzle, follow the procedure below.
1. Remove the screw (1) from the second nozzle (2) and then remove the top nozzle
(3) and dispersion cover (4).
(2)
(3)
(4)
(1)
20