Matrox Meteor Installation And Hardware Reference page 41

40 Appendix A: Troubleshooting
Not enough memory to allocate buffer under Windows NT
4.0
This is a message that you will receive if you allocate a grab
buffer that is greater than the amount of the DMA memory
specified at the time of software installation. This problem can
be addressed by allocating more memory. To do so, type the
following line at the Windows' run prompt:
yuxp„ˆÂyq†q„„q‚xgiq
Replace x with the appropriate amount of the DMA memory in
Kilobytes. Note that for every x amount of DMA memory
required, Windows NT reserves twice that amount as
non-paged memory, only half of which is accessible to the user.
Linking or compiling error under DOS
To avoid running into this problem, install MIL-Lite (versions
5.0 or greater) after installing Watcom Version 11.
Not enough environment memory under DOS
This is a message that you might receive when you try to boot
your PC. To address this problem, add the following command
in your config.sys file:
…tqxx1i(biyyg€piyÂq("'$
Incomplete field
You will receive a message that a field has been dropped, if some
data was lost while grabbing continuously. With the latest
version of PCI chipsets, included in the newer PC models, you
should not run into this problem any more. However, should
you still encounter this problem, disable error messages by
calling the following MIL-Lite function:
Gg‚‚i€†„xGCFg‚‚C8Ge9RRIRGePRCHTe8CS56F9
Note that MilappID refers to your application ID.