Safety And Installation Instructions - Waeco PerfectView CAM30 Installation And Operating Instructions Manual

CAM30_CAM40.book Seite 18 Donnerstag, 14. Januar 2010 5:32 17

Safety and installation instructions

fig. 1 5, page 3: This refers to an element in an illustration. In this case, item 5 in
figure 1 on page 3.
Please observe the following safety instructions.
2 Safety and installation instructions
The manufacturer will not be held liable for claims for damage resulting from the following:
Faulty assembly or connection
Damage to the appliance resulting from mechanical influences and excess voltage
Alterations to the device without express permission from the manufacturer
Use for purposes other than those described in the operating manual
Warning!
e
To prevent the risk of short circuits, always disconnect the negative terminal of
the electrical system before working on the vehicle.
If the vehicle has an additional battery, its negative terminal should also be dis-
connected.
Warning!
e
Inadequate supply cable connections could result in short circuits with the con-
sequence that:
– cable fires occur
– the airbag is triggered
– electronic control devices are damaged
– electric functions fail (indicators, brake light, horn, ignition, lights).
Please observe the following instructions:
When working on the following supply lines, only use insulated cable lugs, plugs and
tab sleeves.
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use terminal strips.
Use a crimping tool to connect the cables.
For permanent connections, you can solder the cable ends together and then insu-
late them.
When connecting to cable 31 (earth), screw the cable
– to the vehicle's earth bolt with a cable lug and a gear disc or
– to the sheet-metal bodywork with a cable lug and a self-tapping screw.
Ensure that there is a good earth connection.
18
PerfectView