Yamaha MODUS H11 Owner's Manual page 50

Keyboard Stand Assembly
3.
Attach B.
3-1
Align the holes on A with those on B and hold A
and B together.
3-2
Finger-tighten six short screws (6×20 mm) start-
ing with the top hole.
3-3
Tighten the screws securely.
A A
4.
Attach C.
4-1
Align the holes on A with those on C and hold A
and C together.
4-2
Finger-tighten four short screws (6×20 mm)
starting with the top hole.
4-3
Tighten the screws securely.
A A
50
H11 Owner's Manual
5.
5-1
B B
5-2
5-3
Hold E securely to avoid slippage.
C
Assemble the pedal structure.
Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
D D
E E
Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4×6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
D D
E E
CAUTION