Advertisement
● The bracket is suitable for concrete wall mounting or wooden stud wall or calcium silicate board(screws M6x55
must be attached to the stud and securely fastened。
● Concrete wall mounting thickness must be a minimum 4'' ,Anchor bolt and screw (M6 x55) are needed to be used for concrete wall installation.
●
W
ood stud wall
must be a minimum 20x12 inch, Stud thickness must be a minimum 3'' .
If the wall is not strong enough reinforce it sufficiently before installation.
● Calcium silicate board mounting, screws M6x55 must be attached to the stud and securely fastened.
● All of the fastening screws provided have to be used 。
● Please contact
manufacturer
Take off the cap
Loosen the screw
The arrows up
screw (M6 × 55) and anchor bolts are needed
for concrete wall mounting.
The cables
Loosen the screws with L3 allen wrench,
pull out the support arm around
and make power cable & signal cables go
through the support arm.
Pg.4
if you have any questions about mounting surface issue.
A
C
The arrows up
D
4'' (100mm)
and gypsum board thickness not
ø10~11mm
Concrete wall mounting
ø3mm
Wood stud wall
For wood stud or calcium
silicate board mounting,
screws M6x55 must be
attached onto the center of
stud and securely fastened.
A
C
These four screws must be
fastened on the stud.
Only screw (M6 × 55) are needed
for wood stud wall or calcium silicate board mounting.
The cables
The cables can be got through the wall plate
by three ways as shown in the pictures. Then,
Lock the screw "F" , but not tighten it.
Note : You have to push the arm outward about
3mm before it can be installed.
greater than 3/8 inch
>55mm
Use anchor bolt
>55mm
Not use anchor bolt
Or
The arrows up
These two screws must be
fastened on the stud.
The cables
B
A
C
Advertisement
