Keyboard Stand Assembly - Yamaha ARIUS YDP-181 Owner's Manual

Keyboard Stand Assembly

Keyboard Stand Assembly
CAUTION
• Assemble the stand on a hard and flat floor with ample space.
• Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please
assemble the unit in accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of
incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of the unit.
• To disassemble the unit, reverse the assembly sequence given below.
Have a Philips-head (+) screwdriver of the appropriate size ready.
Remove all parts from the package and make sure you have all of the items.
Foamed styrol pads
Remove foamed styrol pads from the package, position
them on the floor, then place A on top of them.
Position the pads so that they will not hide the connectors
on the bottom of A.
A bundled pedal cord is attached to the reverse side.
D
58
Owner's Manual
A
B
C C
E
Assembly Parts
6 x 20 mm long screws x 4 4 x 20 mm tapping
screws x 4
6 x 16 mm short screws x 4 Cord holders x 2
4 x 12 mm thin screws x 2
Headphone hanger
4 x 10 mm thin screws x 2 Headphone hanger
Power cord Adjuster (x 1)