Yamaha MusicCAST MCX-1000 Owner's Manual page 139

Digital audio sever
Hide thumbs Also See for MusicCAST MCX-1000:
Table of Contents

Advertisement

SYMPTOM
The time setting on the MCX-
1000 is in correct.
There is a gap between MP3
songs.
There is no sound from analog
inputs.
Playback is delayed or starts at
the wrong place on the CD.
The speakers emit a humming
sound.
The remote control does not
appear to function correctly.
Using the remote contol causes
problems operating your
television.
Functioning of your TV is
impaired.
Playback on the MCX-A10 skips
or pauses.
CAUSE
The power cord has been disconnected
from an AC outlet for more than 1
minute.
MP3 songs are encoded individually.
The external component is not
connected correctly.
The external component volume is low.
The CD is scratched or dirty.
Connect your components correctly.
The batteries in the remote control are
exhausted.
You are attempting to operate the
MCX-1000 from too far away.
You are not aiming the remote
controller at the MCX-1000.
Bright light (such as sunlight or light
from a fluorescent lamp) is striking the
remote control sensor.
You are using the remote control near a
television you can also operate with a
remote control.
The television is using an indoor
antenna.
You are using close to the maximum
number of MCX-A10 units and
simultaneously playing, storing, or
editing on the MusicCAST server.
139
REMEDY
→ The MCX-1000 holds backup data
for no longer than 1 minute after the
power cord is disconnected from the
AC outlet. Disconnecting it for
longer than this will reset the internal
clock. Reconnect the power cord
within one minute of disconnection.
This is not a defect in the MCX-1000.
Correct the component correctly.
Increase the volume of the output from
the external component.
Check the CD, and replace it if
necessary.
Connect the stereo pin cables firmly.
Replace both batteries with new ones.
Use the remote control within a 60
degree arc, no further than 6 meters
from the MCX-1000.
Relocate the MCX-1000 so that no
bright light strikes the remote control
sensor.
Relocate the MCX-1000 or cover the
remote control sensor of the television.
Use an outdoor antenna with your
television.
Reduce the number of MCX-A10 units
to which the MCX-1000 is distributing
music, or stop any operation you are
performing on the MCX-1000.
Appendix
PAGE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents