Tuner Operations; Listening To The Radio; Manual Tuning; Automatic Tuning - Yamaha CRX-M5 Owner's Manual

Listening to the radio

You can find radio stations automatically, if station
signals are strong and there is no interference.
However, if signals of the desired station signal is
weak, you must tune to it manually.
POWER CT TIMER CLOCK SET
/
RDS PTY RT TUNING
TIME REP EDIT
FM/AM ST/MONO DISC
1 2 3
MEMORY PRESET
PGM
/
TUNER CD
1 2 3 4 5
6 7 8 9 0
REC/ REC/ CD
PAUSE MUTE SYNC
+10
/
TAPE
MD
INPUT SLEEP MUTE VOLUME
– +

Automatic tuning

1
Press INPUT so that the frequency of the radio
station appears in the display.
2
Press FM/AM to select the reception band.
CH
Selected band
3
Press and hold TUNING / (for a higher frequency)
or ? (for a lower frequency) for more than 2
seconds, then release the button.
TUNING / /?
FM/AM
INPUT
STEREO
MHz

TUNER OPERATIONS

4
The unit starts searching for a station.
TUNED
CH
Station frequency
When the unit finds a station, the unit stops
searching and "TUNED" appears in the display.
5
If the located station is not the desired one, repeat
steps 3 and 4 until your desired station is heard.
Notes
• If automatic tuning search does not find the desired station,
try manual tuning as described below.
• When an FM stereo broadcast with sufficient signal strength
is received, "STEREO" appears in the display and you can
listen to stereo sound.

Manual tuning

1
Follow steps 1 and 2 described in "Automatic
tuning."
2
Press TUNING / (for a higher frequency) or
a lower frequency) to select your desired station.
• Each time you press TUNING
frequency changes step by step.
Note
• If an FM program is noisy, press ST/MONO so that
"STEREO" disappears from the display. There will be no
stereo effect, but the reception will improve. Press this
button again to restore the stereo effect.
One touch play
You can switch from another source to the radio just by
pressing FM/AM. In this case, the unit tunes to the last
received station.
Using the //? buttons on the front
panel
The //? buttons on the front panel work as the
TUNING //? buttons or PRESET //? buttons. To
change a part, press TUNING/PRESET on the front
panel. Each time you press TUNING/PRESET, the item
changes.
Getting Started Playing CDs
STEREO
MHz
? (for
or , the
/ ?
E-13