Before First Use; Operation; Adjusting The Temperature; Tinning The Iron Tip - Westfalia Wetekom JLT-01 Instruction Manual

Before first Use

Take the unit out of the package and dispose of the packaging material (e. g.
plastic bags) or store it out of the reach of children. There is a danger of
suffocation!
Operating
1. Place the soldering iron station on a level and solid surface.
2. Mount the iron holder (1), as shown in the figure and
insert the holder into the left holder slot (3). To
mount the iron holder on the right side of the iron
station, turn the bracket holder (2) to 180°.
The iron holder can be upturned around 45°. Adjust
the iron holder to the desired position and tighten
the screw.
3. Insert the plug of the iron into the suitable socket
(10) at the left side of the station.
4. Turn the temperature controller (7) to the light in direction to MIN and
insert the power plug into a wall socket.
5. Switch on the iron station by pressing the ON/OFF rocker switch (9) and
place the iron into the iron holder.

Adjusting the Temperature

1. After switching on the iron station, slide the preset/read switch (8) to the
right into the position SET. The preset value indicator (D) lights up.
2. Adjust the temperature controller to the desired temperature. The adjusted
value is indicated on the digital display (A).
3. Slide the preset/read switch to the left into the position READ. The read
value indicator (C) lights up. As long as the adjusted temperature is not
reached, the heater indicator HEATER ON (B) light up.

Tinning the Iron Tip

Before first use the iron tip must be tin plated.
Apply some solder to the tip of the iron. Adjust the temperature controller to
approx. 220°C and let some solder melt on and flow around the tip. By
reaching the melting point of the solder the entire soldering tip must be evenly
coated with a thin coat of solder.

Operation

9