Vecow MTC-7000 Series User Manual page 57

4.4.2.2 SATA And RST Configuration
Figure 4-4-2-2 : SATA Devices Settings
SATA Controller(s)
Enable or disable SATA Device.
SATA Mode Selection
Determines how SATA controllers operate.
Software Feature Mask Configuration
RST Legacy OPROM/RST UEFI driver will refer to the SWFW configuration to
enable/disable the storage features.
Aggressive LPM Support
Enable PCH to aggressively enter link power state.
Options for each SATA port.
Port n
Enable or disable SATA port.
Hot Plug
Designates this port as Hot Pluggable.
Spin Up Device
On an edge detect from 0 to 1, the PCH starts a COMRESET initialization
sequence to the device.
SATA Device Type
Identify the SATA port is connected to Solid State Drive or Hard Disk Drive.
©Vecow MTC-7000 User Manual BIOS SETUP 50