Removing Gun From Welding Power Source - Hobart H-9B Owner's Manual

5-5. Removing Gun From Welding Power Source

8 mm
Remove nozzle. Cut off wire
at contact tip, and remove
contact tip and tip adapter.
Remove wrapper from
unit.
Disconnect trigger leads from
RC3 and RC4 on PC1.
Pull weld cable through
opening in baffle.
OM-225 333 Page 14
Head
Tube
Open pressure assembly. Retract
wire from liner onto spool.
Remove screws (3) from
cover, and remove cover
from wire drive assembly.
Disconnect gas hose from
adapter (if unit is not
equipped with gas solenoid
valve, loosen hose from
wiring harness).
Remove leads and
hose from cable tie(s).
!
Turn off and disconnect input
power.
.
Hold wire tightly to keep it
from unraveling. Secure
end of wire at spool.
Disconnect weld
cable from weld
terminal.
Pull weld cable, trigger leads, and gas hose
through opening in drive housing. Pull gun
cable out through opening in front panel. To
reinstall gun see Section 3-3.
803 497-A / Ref. 803 378-A / 803 838-A