Romus CT200 Operation Manual page 14


One of the two rear wheels is mounted on an eccentric shaft (see diagram).

If the drum has to be adjusted proceed as follows:
Place the planer on an even floor. Lift the machine with the height adjustment hand
wheel, until all the tools are well clear of the floor. Loosen the clamping screw of the
eccentric shaft. On the other side of the rear wheel is a screw which keeps the wheel on
the shaft. Turning the screw will also turn the eccentric shaft. The floor planer moves up
and down on one side. Always turn the screw clockwise. Anti clockwise would loosens
the screw. Keep turning until all the tools on the drum are the same distance to the floor.
Tighten the clamping screw again.
 Bearings :
All bearings are greased for their life time.
 Height adjustment and joints:
All joints have to be greased periodically with a standard machine grease.
 Belt drive :
Check the belts after approximately every 30 hours of operation. To tension the belt you
need to raise the motor bracket. Loosen the 4 M10 screws of the bracket. The front screws
are in two slots. Raise the bracket until the belts are tensioned. Tighten the screws again.
 Cleaning :
Regular cleaning of the machine increases the life of all components and tools of the planer.
Maintenance and cleaning
Diagram
Raboteuse de sol – CT200 | Rèf. 94512
14