Romus CT200 Operation Manual page 12

TCT cutters: Heavy duty, long life cutters for all concrete texturing, scabbling, planing and
grooving applications. Also used for removal of road markings, roof chippings and brittle
coatings
Milling cutters: Primarily for the removal of thermoplastic road / runway markings. Tipped with
tungsten carbide they are cost effective and highly efficient. A range of cutter dimensions are
available.
Beam flails: Heat treated cutters for the removal of paint coatings and laitance from new
concrete. Also for removing grease, dirt and ice deposits.
Attention! The CT 200 floor planers are constructed according to existing safety rules
and regulations. These technical precautions should not be removed or changed
under any circumstances. While operating the machines the following points should
11. The planers should always be operated with all safety covers and technical precautions.
12. The operator should never leave the machine during operation.
13. Before leaving the machine all rotary parts should be brought to a stand still. The electric
models must be disconnected rom the mains. Make sure that the machine cannot roll or
move by itself.
14. After maintenance and adjustment all safety covers must be reattached.
15. If the noise level exceeds 90 dB(A) ear protectors must be worn.
16. In the event of a large amount of dust during operation connect a dust collector to the
planer.
Applications of the tools
Safety rules
SECURITY
also be kept in mind:
Raboteuse de sol – CT200 | Rèf. 94512
12