Audex AS Series Manual page 23

Maintenance Assembly
13. Insert the oil (lip) seal into the bearing housing where present.
14. Place the lower bearing housing over the lower bearing(s) and screw the retention plate to the
bearing housing to secure the assembly.
15. Insert the rotor into the stator, along with the bearing housing, and both upper and lower bearings.
16. Fasten the bearing in place with cap head or set screws (depending on the pump model).
17. Push the upper rotating mechanical seal face onto the shaft until it meets the stationary face.
18. Place the seal spring onto the shaft, followed by the lower rotating mechanical seal face.
23