LA CASTELLAMONTE RNO 200 Instruction Manual For Installation, Use And Maintenance

Hide thumbs Also See for RNO 200:

Advertisement

Quick Links

INSTRUCTION MANUAL
FOR INSTALLATION
USE AND MAINTENANCE
TYPE
RNO 200
MODEL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RNO 200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for LA CASTELLAMONTE RNO 200

  • Page 1 INSTRUCTION MANUAL FOR INSTALLATION USE AND MAINTENANCE TYPE RNO 200 MODEL...
  • Page 2: Table Of Contents

    INDEX CHARACTERISTICS Scheme with legenda THE CHIMNEY FLUE The Chimney fl ue: our stoves’ “engine” THE CHIMNEY FLUE The Chimneypot INSTALLATION p.10 Initial advices OPERATION p.12 Lighting and combustion COMBUSTIBLE p.15 SAFETY p.16 External air inlet Home fi re safety Installation distances from fl ammable material Ceramic Lining Advice On The Safety Of Children...
  • Page 3: Characteristics

    CHARACTERISTICS Collarin uscita fu Smoke e Scheme with legenda collar. Uscita a Canale di conv da fumo. Collarino Conveti Flue pipe. uscita fumi. hot air e Smoke exit Uscita aria calda collar. di convezione. Convetion Uscita aria calda hot air exit. di convezione.
  • Page 4: The Chimney Flue

    SAFETY NOTICE: Fig. 2A IF THIS APPLIANCE IS NOT PROPERLY INSTALLED, OPERATED AND MAINTAINED, A HOUSE FIRE MAY RESULT. REDUCE RISK FIRE, FOLLOW INSTALLATION INSTRUCTIONS. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA.
  • Page 5: The Chimney Flue

    THE CHIMNEY FLUE Fig. 2E The Chimneypot Over the ridge The chimney pot is placed on top of the chimney and helps to expell the smoke. The fundamental characteristics of the chimneypot are: • It must have the same diameter of the chimney flue Reflux area • Useful outlet section not less than twice the minimum of the chimney flue (ex.
  • Page 6: Installation

    INSTALLATION INSTALLATION DISTANCES FROM FLAMMABLE MATERIAL Initial advices • The stove must be installed on a floor with adequate capacity. If the existing building does not meet this requirement, appropriate measures (eg, load distribution plate) must be taken. • The installation must guarantee easy access to clean the stove, the smoke pipes and the chimney flue as well.
  • Page 7: Operation

    N.B. It is also necessary to clean the fireplace area immediately behind the door from OPERATION the ashes in order to keep the primary air inlet open. The ash found in this area can be pushed towards the back of the fireplace or removed. Lighting and combustion Fireplace door If, during the first lighting, the stove should emanate smells due to the evaporation of substances...
  • Page 8: Combustible

    The combustion is good if: COMBUSTIBLE - After the lighting phase, there are no visible smokes from the chimney pot. - The ashes are gray and white and no unburned wood remains. - There is little soot in the chimney and inside the heat exchanger. For a good, environment friendly wood combustion, these are the conditions : The proper combustible is wood.
  • Page 9: Safety

    Home fire safety SAFETY External air inlet Installation and use of the stove should be in accordance with the instructions of the Manufacturer and the local rules of habitability. • When a flue pipe pass through a wall or ceiling particular methods of installation should be applied (protection, thermal insulation, distance from heat sensitive materials, etc) The stove must have the necessary air so as to ensure a regular combustion and a healthy environ- • Never connect the stove to a chimney flue already used for another device.
  • Page 10: Advice On The Safety Of Children

    Advice On The Safety Of Children ASSEMBLY SCHEMES During the stove functioning, the ceramic coating heats up progressively (until 40/50°C) Round Stack - WOOD Base to lose heat to the environment. It is very important to keep the children away from the stove in order to avoid touching the ceramic coating, with the risk of burns.
  • Page 11 ASSEMBLY SCHEMES ASSEMBLY SCHEMES Round Stack - SLIM, RIM, Rondò LONG and SIDE base Chimney flue hole Chimley flue hole 1. Position the fireplace 2. Insert ceramic base 3. Brass door assembly in axis with the flue pipe from above. with 4 M6 screws in the four 1.
  • Page 12: Maintenance

    The installation of the stove must guarantee easy access for its cleaning, as well as for the cleaning La Castellamonte will replace or repair the goods or its individual components when they are found of the flue pipes and of the chimney flue.
  • Page 13 LA CASTELLAMONTE di R. Perino e S. Neri Snc Via Casari, s.n. 10081 Castellamonte (TO) – Italy Tel. 0039 124 581690 Fax. 0039 124 514149 www.lacastellamonte.it - www.stackstoves.com info@lacastellamonte.it...

Table of Contents