Main Boom Lock And Swing Lock Pins; Stabilizer Lock Plates; Extendable Dipper Control (Gx920Xt) - Wallenstein GE Series Operator's Manual

Controls
6.2 Main Boom Lock and Swing Lock
Pins
Swing lock and boom locks pins are provided to secure the
boom when servicing or traveling. The pins prevent the boom
from swinging and keep it in the fully raised position.
Insert the pins with lynch pin retainers before servicing or
traveling with the backhoe.
Fig. 11 – Lock Pins

6.3 Stabilizer Lock Plates

Stabilizer lock plates are located on both sides of the GX720,
GX920 and GX920XT models. The lock plates secure the
stabilizers in place when traveling with the backhoe.
Raise the stabilizer up and swing the lock plate into position to
lock it.
Fig. 12 – Stabilizer Lock Plates
6.4 Extendable Dipper Control
The GX920XT has an extendible dipper stick to provide extra
reach. It is capable of hydraulically extending an extra 24"
(61 cm). The extension allows digging to depths of 11'-4"
(3.5 m).
A foot pedal on the left-hand side of the console controls the
extender cylinder. Flip the pedal cover up to use the foot pedal
control.
00997
Operation hazard – Replace the foot control
cover when not in use. Backhoe could move
unexpectedly.
00998
26
(GX920XT)
Fig. 13 – Foot Control Cover
CAUTION!
GE, GX Series
Backhoe
00954
W066