Replacing Damaged Safety Signs - Wallenstein GE Series Operator's Manual

Table of Contents

Advertisement

GE, GX Series
Backhoe
7. Electrical Cables/wires
Warning! Risk of electrocution resulting in serious injury or
death. Stay at least 20 ft (6 m) away from overhead electrical
cables. Electrocution is possible (from arcing) without direct
contact.
8. Hydraulic System
Warning! Risk of serious injury from injection of high-pressure
fluid. Never check for leaks with your hand or finger when
system is pressurized. Use caution when removing panels or
shields or disconnecting hydraulic connections.
9. Buried Utilities
Warning! Risk of serious personal injury or damage to the
backhoe. Be aware of the location of buried utilities (cable,
pipes, electrical conduit). Have an underground utility locating/
marking service survey the area before digging.

3.3 Replacing Damaged Safety Signs

• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or have become
illegible.
• Parts that were replaced with a safety decal on them must
also have the safety sign replaced.
• Replacement safety signs are available from your
authorized Distributor, Dealer Parts Department, or
Wallenstein Equipment.
Procedure
1. Be sure that the installation area is clean and dry.
2. Be sure temperature is above 50 °F (10 °C).
3. Determine exact position before removing from the backing
paper.
4. Pull the decal off the backing sheet, align the sign over
the specified area, then carefully press the exposed sticky
backing in place.
5. Use a piece of the backing paper to smooth the decal out,
pressing from the center outwards.
6. Small air pockets can be pierced with a pin and smoothed
out using the piece of sign backing paper.
17
Safety Signs

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gx seriesGe 605Gx 620Gx 720Gx 920Gx 920xt

Table of Contents