Advertisement
OUTPUT MASTER / INPUT SLAVE
OUTPUT MASTER / INPUT SLAVE connection makes 2pcs of Digital-series amplifier's daisy chain connection to 2 ohm.
3-2. CONTROL & CONNECTION
GND ( GROUND CONNECTION )
It is connected to the Negative or ground
cables of the Vehicle.
Recommended cable is 0 Gauge.
+12V ( POWER CONNECTION )
This must be connected to the fuse positive
terminal ( +12V ) of the battery.
Recommended wire is 0 gauge .
4. INSTALLATION
In case you install Digital-series by yourself, please read owner's manual and follow
your installation steps very carefully. Before you start your installation, please take all steps
into consideration. or, you can have u-DIMENSION authorized distritutors to check installation
and set your car audio systems
4-1. MOUNTING PREPARATION
Disconnect the negative ( ) battery cable before mounting Digital-series amplifiers or
making any connections. Check the battery and alternator ground ( ) connections.
Make sure they are properly connected and Free of corrosion
Before selecting a mounting location for amplifier, Pls take some concerns into consideration
with cooling efficiency and safety.
REM ( REMOTE )
It is connected to switched +12V with a Trigger cable
coming from the head unit
SPEAKER OUTPUTS
it connects amplifier to speakers. Minimum speaker
cable is 12 gauge.
Minimum impedance is 1 ohm.
Minimum impedance at linked use is 2 ohm.
Advertisement
