Dip Switch; Dip Switch Settings; Display Switch Settings - GE ASYW09CRAWA Service Manual

DIP Switch

DIP Switch Settings

The PCB for the indoor unit of the Tempo series of single
zone mini-splits has a set of DIP switches that must be set
when replacing the PCB.
The replacement PCB is shipped with all switches set to the
OFF position.
Switch settings:
SW2-1 Selects remote code A or B. Normally set to the
position for code A operation.
If two indoor units are used in the same area and the user
wishes to control them separately, switch SW2-1of the
second unit is set to the ON position for code B operation.
The wireless remote for the second unit is also set to code B.
SW2-2 Selects room card able or disable.
Normally set to the OFF position. Set to the ON position
when used in conjunction with a room card interface utilized
in hotel rooms.
SW-3 & SW-4 Selects eeprom code 22, 25, 33 and 35. Set to
identify the tonnage of the unit.
Settings:
9K 9K 9K (22) (23) (23) SW SW SW-3 -3 -3 -3
12K 12K 12K 12K 12K 12K (26) (25) (26) (26) (26) (26) SW-3 SW-3 SW-3 SW-3 SW-3 SW-3
18K 18K 18K 18K (33) (33) (33) (33) SW-3 SW-3 SW-3 SW-3
24K 24 24K 24K (35) (35) (35) (35) SW-3 SW-3 SW-3 SW-3
PAGE 18
OFF OFF OFF ON SW-4 SW-4 SW-4 SW-4 OFF OFF OFF ON
OFF OFF OFF OFF OFF ON SW-4 SW-4 SW-4 SW-4 SW-4 SW-4 OFF ON ON ON ON ON
ON ON ON ON SW-4 -4 OFF OFF
ON ON ON ON SW-4 -4 ON ON
REMOTE CONTROL FUNCTIONS

Display Switch Settings

The PCB for the indoor unit of the Tempo series of
zone mini-splits has a set of Display switches that must be set
when replacing the PCB.
Switch settings:
If two indoor units use different Display, or different PCB,
the PCB should switch J1 and J2. J1 set ON, meaning J1 should
be connected, J2 set OFF, meaning J2 should be cut.
Settings:
9K 9K (23 (23) ) SW SW
09K (387) J1: ON, J2:ON
J1: ON, J2:ON
12K (387)
(387)
18K J1: ON, J2:OFF
(387)
24K J1: ON, J2:OFF