Installation and Operating Specification ETR
4 Mounting
4.1 General notes
Attention!
Before installation remove the device from the packing and check for any possible
•
shipping damage! Start-up is not allowed in the case of transport damage!
Do not mount equipment on vibrating base!
•
When mounted onto lightweight walls, there must be no impermissibly high vibrations
•
or shock loads. Any banging shut of doors that are integrated into these lightweight
walls, can result in extremely high shock loads. Therefore, we advise you to decouple
the devices from the wall.
Do not allow drilling chips, screws and other foreign bodies to reach the device
•
interior!
The device should be installed in a location where it will not be disturbed, but at the
•
same time can be easily accessed!
•
Care must be taken to avoid direct radiation from the sun!
The device is designed for vertical installation (bottom cable inlet). A horizontal or
•
reclined installation is only permissible after technical release of the manufacturer!
Remove the connection cover for mounting and connection, and subsequently close
•
it again carefully.
Use the templates printed on the device packing to mark the fastening bore holes.
•
Assemble the device on a clean and stable base. Do not distort during assembly! Use
•
the appropriate mounting devices for proper installation of the unit!
Drilling template on packing
Schraube
max
4,5 mm
screw max
4,5 mm
91 mm
Gehäuse / housing
106 mm
4.2 Installation location for agriculture
When using for animal keeping, do not install the device directly in the stable but in a
separate room with a lower pollutant load. This helps to avoid damages caused by
pollutant gases (e.g. ammonia fumes, hydrogen sulphide fumes).
L-BAL-E293-GB 1841 Index 001
Bohrschablone
drilling template
Vertical mounting
1 Lid screw (tightening torque 1.1 Nm)
Part.-No.
6/19
Mounting