Related Manuals for MOBILUS Cosmo|L
Summary of Contents for MOBILUS Cosmo|L
- Page 1 THE COSMO|L REMOTE CONTROL MOBILUS MOTOR Spółka z o.o. ul. Miętowa 37, 61-680 Poznań, PL tel. +48 61 825 81 11, fax +48 61 825 80 52 VAT NO. PL9721078008 www.mobilus.pl Version 1.3ENG, 171020...
- Page 2 2. Select the right channel ( unless it is a 1-channel control COSMO | L1 ). - Fig. 2b. 3. Enter MOBILUS motor, serie R in the PROGRAMMING MODE. 4. Press the STOP and UP buttons (on the back side of the remote control) and hold them until the drive does two half turns.
- Page 3 CONTINUED 02. LOADING THE REMOTE CONTROL INTO THE TUBULAR MOTOR MEMORY WARNING! If it is the first remote control loaded into the receiver, this is the MASTER remote control and the motor will change to the operating mode. Using the MASTER remote control, it is now possible to operate the motor or program other remote controls.
- Page 4 LOWER AREA is not pressed before the transmitter changes to the standby mode, the newly selected combination of channels will not be saved ( after waking up the device from the standby mode by pressing the UPPER AREA lub LOWER AREA ) the previous combination will be used ).
- Page 5 NOTE After putting the remote control into the frame, there is no access to the STOP button. To stop the motor, press the opposite area of the panel. This rule applies only to the COSMO operating pilot L with COSMO receivers.
- Page 6 | 2WAY. Control remotes COSMO | L1, COSMO | L5 are not bi-directional remotes, ie they are not capable of displaying feedback. If you need to change the mode to an older version (for example, if you purchase a new remote control for older COSMO radio tubular motors), follow these instructions: 1.
- Page 7 08. NOTES...
- Page 8 • In case of failure the device should be provided for repair with proof of purchase. Defects found during the warranty period will be removed free for no longer than 14 working days from the date of acceptance of device for repair. The manufacturer MOBILUS MOTOR Sp. z o.o.
Need help?
Do you have a question about the Cosmo|L and is the answer not in the manual?
Questions and answers