Harken 3168 Installation Sheet

I N S T A L L A T I O N S H E E T
N15W24983 Bluemound Rd., Pewaukee, WI 53072-4974 USA
Web: http://www.harken.com • Email: harken@harken.com
Read instructions before you cut or mount track
It may be necessary to put trim caps, control blocks and traveler car on track
before mounting. Slide control assemblies onto track with bumper facing car.
Keep control assembly loose so it can be moved out of the way while installing
track.
To cut track to length, make sure stop holes for control blocks do not interfere
with hole for mounting track. If necessary, cut both ends of track.
To determine correct track length, make sure track ends, without trim caps, are
/ " (21 mm) from edge of cockpit coaming.
13
16
Through-bolt track using
bolts, see instruction sheet for correct installation.
/ "
13
16
(21mm)
Position control block flush with end of track. Drive screw firmly against
top surface to mark track, then loosen. Slide control block away.
IMPORTANT: Drill
Do not use screw hole in control block as drill guide.
1846, 3154, 3155, 3159
Secure control block to track by tightening correct screw into hole.
IMPORTANT: Insert loop down from above.
Remove any burrs on edges of track. Press 3157 or 3158 trim caps in place.
Big Boat Control Blocks,
Track and Trim Caps
Control Blocks: 3168, 3169, 3170, 3171
Track: 3154, 3155, 3156, 3159
Trim Caps: 3157, 3158
Telephone: (262) 691-3320 • Fax: (262) 701-5780
Yes
No
Cockpit Installation
/ " (8 mm) flathead screws. 3156 Track uses slide
5
16
Install Control Blocks
3 / " (83 mm)
1
4
/ " (10.5mm) hole only through top suface of track.
27
64
Use 25 mm Screws
Dead-ending Line at End Control
Install Trim Caps
Cut Track
Mount Track
Use 45 mm Screws
Drill Size
/
27
64
3156
" (10.5 mm)