Advertisement
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try correct the interference by one or more of the following
measures:
1.
R eorient the receiving antenna.
2.
I ncrease the separation between the equipment and receiver.
3.
C onnect the equipment into and outlet on a circuit different from that to which the
the receiver is connected.
4.
C onsult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction
manual.
WARNING:
A shielded-type power cord is required in order to meet FCC emission limits
and also to prevent interference to the nearby radio and television reception. It is
essential that only the supplied power cord be used. Use only shielded cables to
connect I/O devic e s to this equipment.
CAUTION:
A ny changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Advertisement
