Advertisement
Installing the Matrix Pagers
The first consideration in the placement of the transmitter is convenience. It should be
readily accessible in a central location within the paging area. Pay close attention to
nearby obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers
that may weaken or misdirect transmitted signals. Certain materials and construction,
especially metal, have the potential to partially or completely block the paging signal.
The next consideration involves safety.
Ensure the unit is securely mounted or set in an area away from liquids, extreme heat
and possible physical damage. Also remember that the transmitting unit requires a
110V AC power outlet. Ideally the transmitter should be centrally located within the area
where paging is to occur. See the special function section of this guide entitled 'Range
Test' for more information. Also consult your Sales Consultant for additional information.
Once the Transmitter has been installed, plug in the power adapter. Once powered, the
transmitter will display "Enter Number'' indicating it is ready to send a page. We
recommend some type of surge suppressor on the power supply for protection. Power
surges are not covered under system warranty!
T he Matrix Pagers are used in conjunction with several of the Pagertec transmitters.
The guest pagers are used as an on-premise paging system to increase efficiency by
alerting customers who are waiting, usually for services or goods.
CHARGER INSTALLATION
1 .
I nstall the charging base per the directions received with the charger kits.
2.
C harge pagers for 24 hours prior to first use. Note: Keep rechargeable pagers on
charge even during extremely long periods of inactivity.
WARNING:
D o not connect more than 2 charger base stations to a single power supply.
Advertisement
