Advertisement
Only use the power supply that came with your charger. Damage caused from improper
electrical connection including but not limited to the incorrect power supply is not
covered under the standard warranty. If you're uncertain about which power supply to
use, contact our customer support department.
OPERATION
1. When a guest arrives, remove a pager from the charging station. Pagers will light
up for 1 second.
2. Record the pager number and hand to your guest.
3. Page the pager by entering the number into the transmitter.
4. Pagertec Matrix Pagers will flash or vibrate (if enabled) depending on the page
mode that is selected.
5. Transmitters can also send predefined time limits for each of the pager alert
modes.
CLEANING
Pagertec pagers are made from industrial-strength, polycarbonate material. However,
this material is susceptible to hairline cracking if non-approved cleaners are used. When
cleaning Pagertec pagers, you should only use ETHYL ALCOHOL (ethanol) or
ISOPROPYL ALCOHOL-BASED CLEANERS. We have done extensive testing with
available cleaning materials and have not found any issues with either ethyl alcohol
(ethanol) or isopropyl alcohol (IPA). ALL other cleaners are not recommended for use
on any of our pagers. To clean the equipment:
1. Take a clean cloth and an isopropyl-alcohol based cleaner
2. Wet the clean cloth with the isopropyl alcohol cleaner
3. Wipe down the pagers or equipment
4. When dry, place rechargeable pagers back on charge
Advertisement
