Roberts Gorden Vantage CTHN-40 Kit Instructions page 28

VANTAGE ® NP F C I
UEL ONVERSION NSTRUCTIONS
Tubes
Gas Line
Burner Observation
Window
Blower Scroll, Wheel and
Motor
Burner Cup and Orifice
Electrode
Thermostat
Suspension Points
Decorative and Protective
Grille (optional)
Lower Clearance Shield
(optional)
Wall Tag
Safety Labels
22
Make sure there are no cracks.
Make sure tubes are connected and suspended securely.
Make sure there is no dirt, sagging, bending or distortion.
Clean or replace as required.
Check for gas leaks.
Make sure it is clean and free of cracks or holes.
Clean or replace as required.
Compressed air or a vacuum cleaner may be used to clean dust and dirt.
Make sure it is clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Replace if there are cracked ceramics, excessive carbon residue, or erosion
of the electrode.
The electrode gap should be 1/8" (3.2 mm).
There should be no exposed wire or damage to the thermostat.
Make sure the heater is hanging securely. Look for signs of wear on the chain
or ceiling.
The grille must be securely attached.
Check that side reflector extensions are installed correctly and secured in
place if necessary. (Decorative grille only.)
Make sure shield is installed correctly and secured in place if necessary.
(Decorative grille only.)
The lower shield must be securely attached.
Make sure shield is installed correctly and secured in place if necessary.
If wall tag is present, make sure it is legible and accurate. Please contact
Roberts-Gordon LLC or your ROBERTS GORDON
if you need a wall tag. See Page 4, Section 2.1.
Product safety signs or labels should be replaced by the product user when
they are no longer legible. Please contact Roberts-Gordon LLC or your ROB-
ERTS GORDON ® independent distributor to obtain replacement signs or
labels. See Page 2, Figure 1 through Page 3, Figure 2.
® independent distributor,