Section 5: Fuel Conversion Instructions; Burner Removal; Door Assembly Removal; Figure 5: Burner Assembly Overview - Roberts Gorden Vantage CTHN-40 Kit Instructions

SECTION 5: FUEL CONVERSION INSTRUCTIONS

WARNING
Severe Injury Hazard
Secure burner to burner tube with bolts and
lockwashers.
Hang heater with materials with a minimum
working load of 75 lbs (33 kg).
Failure to follow these instructions can result
in death, injury or property damage.
NOTE: In order to convert the CTHN-Series heater
for alternate gas, you must access both sides of the
burner. It may be easier to remove the burner to a
workbench; however, it can be converted in place. If
you are converting the burner in place, skip to Step
5.2

FIGURE 5: Burner Assembly Overview

5.1 Burner Removal

Step 5.2 Door Assembly Removal
Remove thumb screws and set aside. See Page 8,
Figure 6.
Burner
Lock
Washer
SECTION 5: F
1. Turn off gas supply valve, disconnect gas from
burner.
2. Turn off power supply and disconnect wires from
burner.
3. Unplug thermostat wires from burner.
4. If outside air is installed, disconnect.
5. Remove the bolts which hold the burner on the
transition tube using a 1/2" wrench.
6. Remove the burner. See Figure 5.
7. Save the gasket (P/N 02568200) or re-install a
new one after conversion.
Gasket
S-Hook
C I
UEL ONVERSION NSTRUCTIONS
Burner Tube
7