Getting Started
Gathering Tools and Test Equipment
To disassemble and reassemble the MAP/100 or MAP/100C hardware, you need
the following tools:
Medium width flat-blade screwdriver
No. 2 Phillips screwdriver
Small needle-nose pliers for moving jumpers
Small wire cutters for cutting cable ties
Antistatic grounded wrist strap
Antistatic grounded work mat
Flashlight or auxiliary lighting if in dimly lit area
Locating Key Components in the MAP/
40
Use the following sections and diagrams to locate key components on the unit.
For additional information describing the MAP/40 hardware, see the system
description for your application.
The Front of the Chassis
See the table below for descriptions and functions of components on the front of
the chassis that are important for this kit. Figure 1-4 shows the front view of the
MAP/40.
1-8