Table of Contents
Advertisement
After selecting SRC, the Tally color changes from "Inactivea" to "Active".
The original "DEST" output changes as "SRC" and the Tally color changes to "Inactivea".
3.
Tally Description
The Tally color is red in "Active".
The Tally is off in "Inactivea".
DEST 1-16 Destination selection key
1.
Key Description
Select the DEST source.
Each DEST key corresponds to one output bus signal.
Each output DEST key has two states:
"Active": "DEST", then the operation for this channel is enabled.
"Inactivea: non-current "DEST".
2.
Instructions
In "Inactivea", pressing this key will trigger the following actions:
Select DEST, the status change to "Active". And the the original "Active" DEST "changes to"
Inactivea ".
The Tally of the selected "DEST" changes from "Inactivea" to "Active".
The Tally of the original "DEST" changes from "Active" to "Inactivea".
3.
Tally Description
The Tally color is red in "Active".
The Tally is off in "Inactivea".
"Destination Lock" key
1.
Key Description
"Destination Lock" key, lock, when the selected purposes, the local panel and all panels on
the network can not change the source of the channel.
The key has two states: "Active" and "Inactivea".
2.
Instructions
In "Inactivea", pressing Destination Lock key will trigger the following actions:
The current "DEST" changes into lockdown mode. In this mode, the current "DEST" can not
be changed the input source "SRC" by the local or network panel.
The state of the Destination Lock key changes from "Inactivea" to "Active".
The Tally color changes from "Inactivea" to "Active".
In "Active", pressing Destination Lock key will trigger the following actions:
The current "DEST" changes into un-lockdown mode. In this mode, the current "DEST" can
be changed the input source "SRC" by the local or network panel.
The state of the Destination Lock key changes from "Active" to "Inactivea".
The Tally color changes from "Active" to "Inactivea".
17
Advertisement
Table of Contents
