Automatic Scanning; Continuous Scanning; Configuring The Scan Demo Application; Scan Settings - Honeywell Dolphin 75e User Manual

Automatic Scanning

Enable Automatic scanning mode to activate the ring scanner for continuous scanning without requiring the operator to
press the trigger for each bar code presented in the field of view. To configure the time interval between scan attempts, see
Auto Scan Delay under
1. Slide the Automatic blue button to the ON position to enable the feature.
2. Press the ring scanner trigger to activate the ring scanner. Once activated, the ring scanner automatically scans and
decodes bar codes presented in it's the field of view.
3. To turn off Automatic scanning slide the blue button to OFF.
4. Slide the Automatic blue button to the OFF position to disable the feature.

Continuous Scanning

Enable Continuous scanning mode to activate the imager for continuous scanning only when the operator touches and
holds Scan or presses and holds the Scan button. The time interval between scan attempts is minimal and not configu-
rable.
1. Slide the Continuous blue button to the ON position to enable the feature.
2. Press and hold trigger to activate the ring scanner. The ring scanner scans and decodes bar codes presented in the it's
field of view as long as the trigger is pressed.
3. Release the trigger to deactivate the ring scanner.
4. Slide the Continuous blue button to the OFF position to disable the feature.

Configuring the Scan Demo Application

1. Open the Scan Demo application, and then press the Menu button
2. Touch Scan Settings, Symbology Settings, or Notification Settings.
3. Modify the settings to meet your application needs, and then press the Back button

Scan Settings

Touch the check box to enable or disable a feature. A check mark indicates enabled.
Setting
View Statistics
Auto Scan Delay
Auto Send
RF Configuration

Symbology Settings

For information on these settings,
Configuring the Scan Demo Application
Description
When enabled, scan results displayed include the length of bar code, the
number of scans completed, the number of milliseconds (ms) to decode
the bar code, the average decode time of all the bar codes decoded, the
shortest decode time of all bar codes decoded, and the longest decode
time of all bar codes decoded.
Program the number of seconds between scan attempts by tapping the
menu arrow, and then entering the delay interval in second. The value
should be greater than 0 and less than 100000. Touch OK to save.
When enabled, decoded data is sent to a designated server.
Touch to view and/or edit the Server IP address and the Port used for RF
communication. When the Back button is pressed, the terminal attempts
to establish communication.
Symbology Settings
(page 4-7).
.
on page 4-5.
to return to the Scan Demo screen.
Default Value
Enabled
1
Disabled
4 - 7