Advertisement
INSTALLATION PROCEDURES
INSTALLER NOTE: It is important to correctly follow
these assembly instructions. These instructions for
assembly are provided by the manufacturer at time
of Access Ladder delivery, and reflect the technical
specifications applicable at the time of writing.
•
These instructions are subject to change if the manufacturer revises
the parts and/or production of the subsystems and accessories used in
the brand's vehicles. Following the instructions for assembly will ensure
proper installation of the product. The manufacturer will not be held
liable if these instructions are not followed.
•
This Access Ladder is designed to be installed in one specific position
on the vehicle. Attachment to the vehicle may be compromised if the
position is different from that shown in these instructions.
•
Do not add or place any additional material (rubber, plastic, etc)
between the Door Brackets and the vehicle's body unless supplied
with your Access Ladder. The use of additional nonessential material
may prevent proper holding of the Access Ladder to the vehicle's door,
leading to vehicle body and/or Ladder damage.
•
The vehicle's door must be securely closed and latched at the top and
bottom prior to using this Access Ladder. Failure to do so may cause
damage to the vehicle's door & hinges, and/or cause personal injuries.
•
The addition of parts and/or components not original to this Ladder
Assembly are discouraged. Use only OEM supplied parts.
•
It is essential to check and retorque the mounting fasteners after the
first week of initial service, then monthly thereafter.
ACCESS LADDER ASSEMBLY
SEQUENCE
1
PRIME DESIGN, A SAFE FLEET BRAND 1689 Oakdale Avenue #102, West St Paul, Minnesota 55118 ▪ Phone: 651-552-8554 ▪ 1.8.PRIME.RACK ▪ Fax: 651-552-1799 ▪ Email:info@primedesign.net ▪ www.primedesign.net
TM & © 2015 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6092974, 6764268, 6971563, 2364879, 8857689, 8511525, 8991889 AND OTHER PATENTS PENDING
2
•
Do not use power tools to tighten fasteners as power tools may lead
to overtightening and cause damage to the vehicle, or the Ladder
hardware. Use only hand tools as shown below.
Torque Wrench w/13MM Socket
Ratchet w/13MM Socket
Combination Wrench, 13MM
Torpedo Level
Tape Measure
Grease or Wax Pencil
LOWER MOUNTING HANGER RODS
1.1
This Lower Mounting
Hanger Rod comes from
the factory pre-assembled.
It is necessary to remove
the tightening hardware
for installation into the
Hanger Rod Clamps as
seen in Step 1.2
3
Advertisement
