Xerox DocuPrint 4508 User Manual page 61

Table 6.2 RCP and SM messages (continued)
Message
PAPER TRAY OPEN
OR EMPTY
PORT IS NOT
AVAILABLE
UNKNOWN STATUS
R e m o t e C o n t r o l P a n e l a n d S t a t u s M o n i t o r M e s s a g e s
Condition/Problem
The printer has run out of paper.
The paper tray is open or not installed
properly.
The printer is not communicating with
the PC/host.
A printer hardware fault condition has
been detected.
Corrective Action
Refill the paper tray with paper.
Fully insert the paper tray into the
printer.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
Verify the parallel interface is connected
to the correct PC/host.
Verify the PC/host is using the parallel
port to establish communications.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
Unplug printer from the wall outlet.
Wait one minute, then reconnect.
If problem persists, contact your dealer
or Xerox/Rank Xerox for technical
support.
C h a p t e r 6 : T r o u b l e s h o o t i n g
Table 6.2 Page 4 of 4
6-7