Related Manuals for U.S.SAWS US60278
Summary of Contents for U.S.SAWS US60278
- Page 1 U.S.SAWS HYDRAULIC BELLY SAW OPERATING MANUAL P: 866 987-7297 F: 813-621-7125 Waterworks Visit us at www.ussaws.com Division sales@ussaws.com...
-
Page 2: Symbols And Labels
S Y M B O L S & L A B E L S THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND THROUGH- OUT THIS MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES. A potentially hazardous situation exists which, if not avoided, WARNING could result in death or serious injury. - Page 3 • Do not operate this machine unless you have received operational and maintenance training from a U.S.SAWS representative or from an authorized distributor for U.S.SAWS . • Observe all applicable local, state, and federal safety regulations. Wear OSHA approved foot protection.
- Page 4 S A F E T Y • The cutoff saw is designed to provide safe and dependable service if operated according to instructions. Read and understand this manual and any decals attached to the saw before operating. Failure to do so could result in personal injury or equipment damage.
- Page 5 U.S.S AW S A I R P O W E R E D B E L LY S AW The U.S.SAWS Air Powered Belly Saw is designed to provide a safe alternative to other cutting methods that can be difficult and dangerous because of the subgrade location of pipes.
-
Page 6: Operation
O P E R AT I O N The US Saws Belly Saw is designed to provide a safe alternative to other cutting methods that can be difficult and dangerous because of the subgrade location of pipes. The key factor that provides ease and safer operation is that the tool is strapped to the pipe and is simply drawn around the pipe creating a straight and efficient cutting process. - Page 7 PA R T S 3. Pull belly saw in the direction of the throttle handle. This will provide the straightest cut. If the tool is pushed from this handle the saw will track of course even if light pressure is applied. Once you reach the termination of the cut you can release the strap and remove the saw.
- Page 8 U.S.SAWS will, at it’s sole option, repair or replace, at the U.S.SAWS factory or at a point designated by U.S.SAWS, any part, which shall appear to the satisfaction of U.S.SAWS inspection to have been defective in material or workmanship.