Cylinder Installation - Ultraflex UC 68-OBS Installation And Maintenance Manual

3.3 Cylinder installation

1 Carry out the
standard installation
on the right side of
the engine (see notice
par. 3.5).
Grease the extention
(1) and the rod (2), by
using marine grease
to prevent the
corrosion of the metal
parts.
2 Insert the first part of the extension (1) into the
tilt tube.
4 Screw the lock collar (4) to the threaded part
of the tilt tube and tighten it with a torque of 40
·
[Nm] (29.5[lb ft]).
4
6 Check the correct cylinder installation by moving manually the engine on the right and on the left.
NO CONTACT
page 12
of 23 -
HYDRAULIC CYLINDER FOR SIDE MOUNT APPLICATIONS
1
l
l
5
l
Installation and Maintenance Manual
3 Insert the cylinder rod (2) in the extention (1)
by locking it by means of the pin (3), then holding
the pin with your hand continue to insert the tilt
tube rod into the tilt tube.
5 Connect the link arm (supplied by the engine
manufacturer) to the extention according to the
engine manufacturer's instructions, then connect it
to the arm, making reference to the data supplied
by the engine manufacturer's instructions.
WARNING
The link arm is supplied wuth the engine and for
its installation follow the manufacturer's
instructions.
NOTICE
When the engine in central position, the cylinder
rod must be in the middle of its stroke.
If it is necessary adjust the ball joint on the link
arm according to the engine manufacturer's
instructions.
WARNING
The engine must stop through the cylinder end stroke
without coming into contact with the mechanical stop (5)
on the engine.
1
2
l
l
3
l