Advertisement
4.
INSTRUCTIONS
4.1.
Prior to use of the required
attachment, disassemble and
grease as shown in fig.1.
Reassemble the attachment.
4.2.
Screw the attachment into the
shaft, as shown in fig.2. Tighten
the attachment using a wrench.
Note: Do not over tighten.
4.3.
Ensure the attachment jaws
are completely closed and insert
the attachment into the inner
diameter of the bearing, fig.3.
4.4
Turn the handle clockwise to
open the attachment jaws to
grip the bearing. See fig.4.
4.5.
Hold the bearing puller as shown
in fig.5, slide the hammer to the
bearing end of the shaft and
then forcefully pull the hammer
to the other end of the shaft.
4.6.
Ensure the bearing is being
pulled out evenly, if not, remove
the puller attachment and, using
a soft faced mallet, tap the
bearing until it is seated evenly.
4.7.
Repeat paragraphs 4.5 and 4.6
until the bearing has been
removed.
4.8.
Turn the handle anticlockwise to
close the jaws in order to
release the bearing from the
attachment head. See fig.5.
Grease
Fig.1
Attachment Head
Tighten
Fig.2
Bearing
Attachment Head
Fig.3
Attachment Head
Fig.4
Attachment Head
Fig.5
Hammer
Open jaws
Hammer
Close Jaws
Loosen
Advertisement
