Advertisement
7A. Drill four ø8mm x 45mm deep holes in the marked locations.
7B. Remove the nut and washers from the supplied Dynabolt and fit
Dynabolt into each drilled hole.
9. Connect the hot and cold water source to the mixer location.
Make sure to purge the pipe before connecting to the mixer.
Test water tightness.
Remove
8. Fit the mixer back into position and secure into place with the
washer and nut of the Dynabolts.
10. Upon completion of floor finish, push the base plate until flush
with floor and covering mixer hole. Silicone is optional under the
inner edge of the plate.
160418EI
Advertisement
