Advertisement
HOW TO INSTALL ON WOODEN FLOOR
A.
B.
1. Preassemble the above parts in the the same order. Make sure
that the tall base plate (D.) is fitted before proceeding.
3A. Fix the small mounting plate onto brass fitting from the
bottom with screws supplied.
3B. Screw the fitted assembly onto bottom of the bath filler.
5. Fix the bath filler assembly, large mounting plate and mixer
together with the supplied screws. Ensure that the supply pipes
are aligned and fitted into the mixer before tightening the screws.
C.
D.
Brass fitting
Small mounting plate
Small screws
Large mounting plate
DISASSEMBLE
2. Remove screws, small mounting plate, protective shell and spirit level.
Diagram A.
4. Using the protective shell as a template to mark the mixer (See
Diagram A). With a hacksaw, cut the floor mounting points of the
mixer as marked. This is so the mixer will fit in the ø100mm hole later
in the installation.
100.0
6. Before cutting the hole, ensure that there is sufficient depth below
the wood floor for the mixer (See Diagram A).
With a hole saw, cut a ø100mm hole in the wood floor. The hole should
not exceed 100mm diameter or there will be insufficient surface area for
mounting the large mounting plate (ø140mm) of the mixer.
Large screws
Small mounting plate
Protective shell
Protective shell
CUT
Wood floor
Finish floor lining
Diagram A.
Advertisement
