INSTALLATION GUIDE
ADESSO DEGREE BATH FILLER DBFSMC
SYSTEM REQUIREMENTS
Equal High (MAINS) Operating Pressures
Operating Hot Water Temperatures
Operating Cold Water Temperatures
Do not plug outlet when testing.
This mixer is recommended for equal high (mains) pressure water supply only.
To ensure the optimum performance and customer satisfaction please adhere to the following:
•
Flush out all pipe work prior to installation.
•
Minimum flow pressure for satisfactory operation: (Hot and Cold) 150kPa
•
Maximum static water pressure: 500kPa. If the water pressure exceeds or is likely to exceed 500kPa, an approved pressure
limiting valve must be fitted.
•
Maximum hot water temperature: 60˚C. If the water temperature exceeds 60˚C, an approved tempering valve must be fitted.
•
Installation should comply with relevant local authority requirements.
•
In accordance with good plumbing practice, filters should be fitted to supply lines to eliminate damage to the ceramic cartridge
from suspended solids.
•
AS/NZS 3500.1 states that pressures above 500 kPa can cause damage from water hammer, reduce the life of
appliances, taps & fittings, cause excessive noise in the system and recommend that a pressure limiting valve (PLV) be fitted.
Failure to comply with the above will void all warranties.
WHAT IS IN THE PACK
Bath filler spout
Short base plate
(Concrete install)
Tall base plate
(Wood install)
Brass fitting
Small mounting plate
Spirit level tool
Protective shell
Bath filler mixer
BEFORE INSTALLATION
Pipework MUST be purged before connecting to the mixer
MINIMUM
MAXIMUM
150kPa
500kPa
55° C
5° C
Wood screws
Large mounting plate
(Wood install only)
Supply hoses
Small screws
Dynabolt
(Concrete install)
60° C
N/A