Yamaha HTR-5230 Owner's Manual page 40

DELAY TIME AND SPEAKER OUTPUT LEVELS
Adjustments should be performed with the remote control
while watching the information on the display
!J
Press
+
or - to adjust the
delay time or speaker
output levels.
1
3
2
o
Press AMP(TUNER) on the
component selector.
6
Press TIME/LEVEL repeatedly to select the
item you want to adjust.
Each time you press TIMEILEVEL, the selected item
changes and appears on the display as below
DELAY
TITLE
T~
NOte
• Depending on the setting of the SET MENU, you may not be able
to select all these items
36
19
Repeat steps 2 and 3 to adjust the settings of
any other item.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost when this unit is set in the standby mode
If, however, the power cord is disconnected from the AC
power outlet or the power is cut for more than one week,
the latest values for the delay time and the center/rear/
subwoofer output levels that were set will automatically
return to the preset values If so, adjust the delay time
and output levels again
DELAY TIME AND SPEAKER OUTPUT LEVELS
Adjustments should be performed with the remote control
while watching the information on the display
!J
Press
+
or - to adjust the
delay time or speaker
output levels.
1
3
2
o
Press AMP(TUNER) on the
component selector.
6
Press TIME/LEVEL repeatedly to select the
item you want to adjust.
Each time you press TIMEILEVEL, the selected item
changes and appears on the display as below
DELAY
TITLE
T~
NOte
• Depending on the setting of the SET MENU, you may not be able
to select all these items
36
19
Repeat steps 2 and 3 to adjust the settings of
any other item.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost when this unit is set in the standby mode
If, however, the power cord is disconnected from the AC
power outlet or the power is cut for more than one week,
the latest values for the delay time and the center/rear/
subwoofer output levels that were set will automatically
return to the preset values If so, adjust the delay time
and output levels again