Table of Contents
Advertisement
4.
Attach the flexible water supply lines to the water shut off
valves. The threaded ends of the water lines can be
wrapped with Teflon pipe tape to ensure a tight, leak-proof
seal. Tighten the fitting with a wrench but do not over-
tighten.
5.
The water lines and waste pipes should now be
completely installed.
6.
Slowly turn ON the hot and cold water shut off valves.
Turn the faucets ON and flush the water lines to remove
any debris that may be in the water line or the drain pipe.
7.
Check all water lines and waste connections for leaks.
Tighten the connection if a leak appears. Do not over-
tighten.
800-325-7008
5. Floor Anchors
A laundry tub(s) that is full of water can weigh from 175 to
LT-011
350 pounds and could tip over if someone pulls against it,
causing personal injuries, death, and/or damage to your
home.
unwanted tipping.
1.
2.
LT-012
LT-013
9
Installation Procedure
WARNING
Securing the legs to the floor will help prevent
As added protection against unwanted tipping of floor
model laundry tubs, secure the unit to the floor using
homeowner supplied anchors.
Adjust the four leveling feet on the legs. A slight angle
(front to back) toward the drain will eliminate water from
standing in the bottom of the laundry tub.
The Swan Corporation – Swanstone
LT-014
LT-015
LT-017
Advertisement
Table of Contents
