Table of Contents
Advertisement
WARNING
Oversized pilot holes may make it impossible to properly
set the anchor and will reduce the anchor's load (holding)
capacity. This reduced holding capacity can result in the
anchor pulling free from the wall, resulting in possible
personal injury or even death.
2.
Drill a 5/16" pilot hole two inches into the concrete or block
wall using a masonry bit and a hammer drill. Clean out
the hole with a vacuum sweeper.
Note: In concrete block walls do not drill the anchor holes into
the mortar joints. These joints typically do not have the
same holding strength as the block itself.
3.
Insert the plastic anchor into the hole and drive it in until it
is flush with the wall surface. For single bowl models use
at least three anchors. For double bowl models use at
least six anchors.
4.
Attach the mounting plate to the wall with 1/4" x 1-1/2"
long Phillips head screws (supplied with unit). For single
bowl models use at least three screws. For double bowl
models use at least six screws.
Note: Make sure the wall mounting plate is straight,
regardless of the wall contour, before completely
tightening the screws. If the wall is not flat, shim behind
the mounting plate, as needed.
800-325-7008
2"
LT-026
LT-027
LT-028
2c. Attaching Wall Mounting Plate to Concrete
or Block Walls with Tapcon Wall Anchors
(User Supplied)
1.
Locate the wall mounting plate in the same manner as
with wood construction.
Note: Trial fit the wall mounting plate to the laundry tub. If the
wall plate is too long, break off the left side of the wall
mounting plate by snapping it along the plate's scored
ridge.
WARNING
Oversized holes may make it impossible to properly hold
the Tapcon screw and will reduce the load (holding)
capacity. This reduced holding capacity can result in the
screw pulling free from the wall, resulting in possible
personal injury or even death.
2.
Drill a 3/16" pilot hole into the wall using a masonry bit
and hammer drill.
Note: Always follow the mounting hardware manufacturer's
recommendation for installation of their mounting
hardware.
3.
Attach the mounting plate to the wall with 1/4" x 1-1/2"
long Tapcon Hex Head Masonry Screws. Do not
overtighten the screws. For single bowl models use at
least three screws. For double bowl models use at least
six screws.
Note: Make sure the wall mounting plate is straight,
regardless of the wall contour, before completely
tightening the screws. If wall is not flat, shim behind the
mounting plate, as needed.
3. Installing the Faucet and Drain
1.
Shut off the water supply to the entire house or at the
location of the old sink.
2.
Release the pressure and drain the water lines by turning
on a faucet in the lowest part of the house. Turn on both
the hot and cold water faucets.
7
Installation Procedure
LT-024
LT-029
The Swan Corporation – Swanstone
Advertisement
Table of Contents
