CipherLab BT 1560 How To Get Started

How to get started with your BT 1560 from Cypher Lab
Your Scanner comes with two parts (a scanner and a cradle) and two cables to
connect the cradle (a) to the computer and (b) to the power.
To connect the power to the cradle
1. Turn the cradle over and look in the bottom of the cradle
Plug the computer
cable in here
2. Now connect the computer cable to your computer and turn the cradle on.
3. Your computer should automatically recognise that this device is connected.
You should see a small message at the bottom of your screen saying "USB
Human Interface Device Installed"
4. When using your barcode for the first time, remember – it is waking up – hold
in the scanner trigger for 3 – 5 seconds until it beeps. Then wait for the
scanner indicator light to show a red bar of light
5. Now, turn over the base unit, there are two small barcodes on the bottom of
the unit
Here are the two barcodes you will
need to scan to activate your scanner.
Plug in the power
cable here