Advertisement
Assembly step
STEP 1
C
5
3
6
Installing Tube(C) on the base(D) and
then put on the Cable clip(E) on
the tube for cable management.
Fixed the brake screw(5) with Allen
wrench(6) to avoid rotation of the tube.
STEP 3
4
2
1
3
8
Installing LCD Mount(B) to Fold arm(A).
Why my monitors keep flopping?
Answer: Please follow steps below to set the tilting angle
1.
SCREWDRIVER
E
D
A
B
2.
90
loose
30
tighten
WRENCH NO.13
STEP 2
7
Put the Fold arm(A) through the Tube(C).
To adjust the height of Fold arm(A)
with Allen wrench(7).
STEP 4
To route your cable from the cable case
which inside of the Fold arm(A) and the
cable clip(E) for a tidy look.
1. Locate the two caps which
are on each side of the axis
of the monitor bracket.
2.
Use a flat-blade screwdriver
to push open the caps.
3. Loosen the nut adjust
the tilting angle then
tighten the nutadain.
A
4
C
A
E
Advertisement
