Cleaning; Placement Within The Shop; Assembly Instructions; Knife Setting Jig - General 30-360 Setup & Operation Manual

CLEANING

The protective coating on the table prevents rust from
forming during shipping and storage. Remove it by
rubbing with a rag dipped in kerosene, mineral spirits
or paint thinner. (Dispose of potentially flammable sol-
vent-soaked rags according to manufacturer's safety
recommendations).
A putty knife, held flat to avoid scratching the surface,
may also be used to scrape off the coating followed
by clean-up with solvent. Avoid rubbing the machine's
painted surfaces, as many solvent-based products will
remove paint.
To prevent rust, apply a light coating of paste wax or
use regular applications of any after-market surface
protectant or rust inhibitor.
PLACEMENT WITHIN THE SHOP / SAFETY ZONE

PLACEMENT WITHIN THE SHOP

This machine should be installed and operated only
on a solid, flat and stable floor that is able to support
the weight of the machine (1397 lbs - 635 kg) and the
operator. Using the dimensions shown as a guideline,
plan for placement within your shop that will allow the
operator to work unencumbered and unobstructed by
foot traffic (either passing shop visitors or other shop
workers) or other tools or machinery.
ESTABLISHING A SAFETY ZONE
For shops with frequent visitors or multiple operators,
it is advisable to establish a safety zone around shop
machinery. A clearly defined "no-go" zone on the floor
around each machine can help avoid accidents that
could cause injury to either the operator or the shop
visitor. It is advisable to take a few moments to either paint (using non-slip paint) or using tape, define on the floor
the limits or perimeter of each machines safety zone. Take steps to ensure that all operators and shop visitors are
aware that these areas are off limits whenever a machine is running for everyone but the individual operating the
unit.

ASSEMBLY INSTRUCTIONS

KNIFE SETTING JIG*

1.
Using a pair of pliers, push a retention ring into the
inner grooves on each end of the knife setting jig
rod as shown A.
2. Slide one foot onto one end of the rod as shown B.
3. Secure the foot on the rod by pushing a retention
ring into the exposed groove in the rod as shown
C.
4. Repeat step 2 and 3 to install the other foot as
shown D. Set the jig aside for use whenever knife
settings need to be verified or adjusted.
*Not included and not needed for 30-360HC
48"
36"
B
A
D
C
22"
9