Related Manuals for logika WL-ZSPDBPW-MT-02
Summary of Contents for logika WL-ZSPDBPW-MT-02
- Page 1 Smart Contact Sensor WL- ZSPDBPW-MT-02 Product Manual Version 1.0 © 2019 Logika Limited...
- Page 2 Introduction Thank you for choosing Logika. Please take a moment to carefully read through the manual to ensure safe and proper installation and use. • Before use, the product must be properly installed as described in this manual by a qualified technician.
-
Page 3: Device Layout
Device Layout Battery Box System Indicator Multi-Function Key Main Body Magnetic Body... -
Page 4: Specifications
Features • Communication Mode: IEEE 802.15.4 Zigbee. Battery operated and easy to install. • • Remote monitor the opening/closing state of door or window. As a security device, pre-set alarm devices can be triggered and send an alert to the phone. •... -
Page 5: Installation Steps
Installation Steps Hardware Installation 1) Remove the base from both the Main Body and Magnetic Body by sliding off the covers. Main Body Main Body Base Magnetic Body Base Magnetic Body 2) Open the battery cover an insert the CR2 battery as shown. Battery Cover Battery... - Page 6 3) Screw the Main Body Base and Magnetic Body Base to the appropriate location on your door or window, using the supplied screws. Door Frame Door Main Body Base Magnetic Body Base 4) Once the bases are fixed to the door/window, slide the Main Body and Magnetic Body back onto their respective base.
- Page 7 Adding the Device to the Smart Home Network Use the Logika Smart Home app to add the device to the Smart Home system. Please refer to the Logika Smart Mobile App user guide which will take you through the process of adding smart devices to the system.
-
Page 8: Device Functions
Device Functions When the device is first powered on, it will normally automatically attempt to connect to the Zigbee Smart Home network. The System Indicator light will flash as it’s searching for the network. If it connects, the light will remain on for 2 seconds and then go out. If this does not happen, you can manually connect via the mobile app and follow the instructions below. -
Page 9: Troubleshooting
You should now be free to add the device to the local smart network. The issue you are experiencing is not mentioned here. Please contact us at support@logika.nz with your issue and we will do our utmost to help!