Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for logika WL-ZOECNPW-B-01
Summary of Contents for logika WL-ZOECNPW-B-01
- Page 1 Smart Doorbell WL-ZOECNPW-B-01 Product Manual Version 1.0 © 2019 Logika Limited...
- Page 2 Introduction Thank you for choosing Logika. Please take a moment to carefully read through the manual to ensure safe and proper installation and use. • Before use, the product must be properly installed as described in this manual by a qualified technician.
-
Page 3: Device Layout
Device Layout System Indicator Status Indicator Power Port Multi-Function Front Back... -
Page 4: Specifications
Features • Communication Mode: IEEE 802.15.4 Zigbee. Used with doorbell button; Get prompts on phone. • • Can bind with other devices for expandability. Easy to install and operate. • A variety of ring tones to select from. • Specifications Communication Mode IEEE... -
Page 5: Installation Steps
Installation Steps Hardware Installation There are 3 ways that the doorbell can be mounted on the ceiling or wall. Each option is described below. Note: The hole for the mains power is 10mm in diameter and the quick connector terminals will accept 14-22 AWG cables. - Page 6 3) Pull the Spring mounts up and push the unit through the hole in the ceiling. Install Option 2 This install option is for mounting without the need for cutting large ceiling holes. For this, you will need the Smart Doorbell, Wall-Mounted Base, wall plugs and screws (supplied). 1) Place the base onto the ceiling or wall and mark off where to drill.
- Page 7 4) Connect the power cable to the Smart doorbell unit and attach to the Wall-Mounted Base attached to the ceiling. Install Option 3 This install option is similar to Install Option 2 but for situations where the cable can only be fed in from the side (i.e.
- Page 8 Adding the Device to the Smart Home Network Use the Logika Smart Home app to add the device to the Smart Home system. Please refer to the Logika Smart Mobile App user guide which will take you through the process of adding smart devices to the system.
-
Page 9: Device Functions
Device Functions When the device is first powered on, it will normally automatically attempt to connect to the Zigbee Smart Home network. The System Indicator light will flash as it’s searching for the network. If it connects, the light will remain on for 2 seconds and then go out. If this does not happen, you can manually connect via the mobile app and follow the instructions below. - Page 10 Binding the Doorbell to a Doorbell Button 1) Press the Multi-Function button 3 times in quick succession. 2) Press and hold the Smart Doorbell Button switch at the same time as tapping its Multi- Function button 3 times in quick succession. 3) If the binding succeeds, the System Indicator on the Smart Doorbell and Smart Doorbell Button will flash 3 times.
-
Page 11: Safety Precautions
Safety Precautions • The device should be mounted in a dry environment. It is not designed to be used outdoors. • Clean with a dry lint free cloth. Please do not use any cleaning liquids to clean the device. • Do not disassemble or refit this product or its accessories. •... -
Page 12: Troubleshooting
You should now be free to add the device to the local smart network. The issue you are experiencing is not mentioned here. Please contact us at support@logika.nz with your issue and we will do our utmost to help!