Related Manuals for logika WL-ZSSMBPW-FD-01
Summary of Contents for logika WL-ZSSMBPW-FD-01
- Page 1 Smart Water Leakage Sensor WL-ZSSMBPW-FD-01 Product Manual Version 1.0 © 2019 Logika Limited...
- Page 2 Introduction Thank you for choosing Logika. Please take a moment to carefully read through the manual to ensure safe and proper installation and use. • Before use, the product must be properly installed as described in this manual by a qualified technician.
-
Page 3: Device Layout
Device Layout Water Sensors Upper Shell Lower Shell Bottom Multi-Function Button System Indicator Battery Compartment Bottom... -
Page 4: Specifications
Features • Communication Mode: IEEE 802.15.4 Zigbee. Equipped with high-sensitive water contact probe. • • Real-time detection of water leaks and sends out alerts. Group linkage with relevant smart devices like Smart Automatic Manipulator to turn off • water valve. •... -
Page 5: Installation Steps
Installation Steps Hardware Installation The Smart Water Sensor is very simple to install. Just insert a CR2 battery into its compartment and place the device where you are likely to have water leaks, like under the sink or bath. But, before you place the device in its final place, be sure to connect the device to the Smart Home network first. - Page 6 Adding the Device to the Smart Home Network Use the Logika Smart Home app to add the device to the Smart Home system. Please refer to the Logika Smart Mobile App user guide which will take you through the process of adding smart devices to the system.
-
Page 7: Device Functions
Device Functions When the device is first powered on, it will normally automatically attempt to connect to the Zigbee Smart Home network. The System Indicator light will flash as it’s searching for the network. If it connects, the light will remain on for 2 seconds and then go out. If this does not happen, you can manually connect via the mobile app and follow the instructions below. -
Page 8: Safety Precautions
Safety Precautions • Make sure the device is placed on a fixed flat surface. • Do not place the device on a metallic surface as this will affect its function. • Do not submerge in water. The device is designed to pick up water leaks by detecting shorts across the three terminal probes on the bottom. -
Page 9: Troubleshooting
You should now be free to add the device to the local smart network. The issue you are experiencing is not mentioned here. Please contact us at support@logika.nz with your issue and we will do our utmost to help!