Xantrex 40 A (XADC-40) Owner's Manual page 9

Towable-OEM-40-60-80A.book Page vii Monday, March 5, 2007 12:15 PM
10. If you need to remove a battery, always remove the
ground terminal from the battery first. Make sure all
accessories are off so you don't cause a spark.
11. Use the XADC for charging a lead-acid battery only. Do
not use the XADC to charge nickel-cadmium or dry-cell
batteries commonly used with home appliances and
electronic equipment. These batteries may burst and
cause injury to persons and damage to property.
12. Never attempt to charge a frozen battery. Charging a
battery when its temperature is below 32 °F (0 °C) is
inefficient and ineffective. If possible, warm the battery
above 32 °F (0 °C) before charging.
FCC Information to the User
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a residential environment. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction
guide, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the
receiver
• Connect the equipment into an outlet on a circuit
different from that which the receiver is connected
• Consult the dealer where the XADC was purchased or an
experienced radio/TV technician for help
975-0305-01-01
Safety
vii