Table of Contents
Advertisement
Facility names and functions (Front) CU-HD1300F-S3
2
1
1
CCU POWER switch
CCU power on/off switch.
2
CAMERA POWER switch
The switch lights during camera power on.
When the camera power is off, only one
channel intercom (CH1) is available.
Press the switch for three seconds or more, to
turn off the camera power.
3
CCU STATUS LED
【POWER】Lights when CCU power is on.
【GL】Lights during genlock operation.
Note: When a different frame rate signal is
input for genlock, the LED blinks and the
signal is ignored.
【OPT】Lights during optical fiber operation
【TRX】Doesn't light.
4
CABLE CHECK LED
【OK】CAMERA POWER
【OPEN】cable not connected
【SHORT】Excess current in cable
Note:
CAMERA
POWER
inoperative when OPEN, SHORT LED is
lighted.
5
CABLE CONDITION LED
【HEAD】The strength of the arriving light signal
from Camera Head to CCU is indicated by
LED.
3
4
5
6
an be operated.
2
switch
2
【CCU】The strength of the arriving light signal from
CCU to Camera Head is indicated by LED.
RED
YELLOW
・Optical fiber operation
Indicate the receiver level approximately.
GREEN1: -3dBm to -8dBm (Normal)
GREEN2: -8dBm to -11dBm
YELLOW: -11dBm to -14dB (Warning)
RED: under -14 dB (Alarm)
When the transmitting condition deteriorates by
cable deterioration, block noise occurs in video
signal..
6
TALLY LED
【R】Lights at red tally input or when CALL signal is
sent from camera.
【G】Lights at green tally input.
7
CALL button
Press to call the camera.
8
PRIVATE/COMM switch
is
PRIVATE : Communicate with camera only
COMM : Communicate with entire system
4
8
10
7
9
11
GREEN2
GREEN1
Advertisement
Table of Contents
