Technical Data; Warranty; Copyright, Trademarks - Pro-Ject Audio Systems Box-Design DAC Box RS2 Instructions For Use Manual

Technical data

Frequency response:
Output voltage:
Sampling rates:
DSD support:
MQA support:
Dynamic Range:
Channel separation:
SNR (20Hz - 20kHz):
THD
THD (20Hz - 20kHz):
USB data transfer:
S/PDIF optical input:
S/PDIF coaxial input:
AES/EBU
I²S:
Master clock output
Digital to Analogue converter:
Filter settings:
Output buffer
Tubes
Display
Analog outputs:
Variable balanced output 1 x XLR connectors
Variable unbalanced output
Trigger sockets:
Outboard power supply: 20V/3A DC, suitable for your country's mains supply
Power consumption:
Dimensions W x H x D (with sockets):206 x 72 x 222 mm
Weight:
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2020. All rights reserved.
20Hz - 20kHz (-0,1dB, -0,2dB)
2,0V RMS - 0dBFS on digital inputs /RCA output
4,0V RMS - 0dBFS on digital inputs /XLR output
32/44,1/48/88,2/96/176,4/192/352,8/384/705,6/768 kHz
DSD64, DSD128, DSD256 and DSD512 (DoP, DSD512 native)
full MQA decoding by hardware from all digital inputs
124dBA
> -117dB at 10kHz@0dB
> 113dB at 0dB
0.0005% solid state output/ 0.03% tube output, @ 2V RMS, 1 kHz
< 0.0008% @ 0 dB, 2V RMS THD+N (20Hz - 20kHz): < 0,001%
Asynchronous, DSD DoP, DSD Native DSD512 support and
PCM up to 32b/768kHz
2 x (24bit / 192kHz)
1 x (24bit / 192kHz)
1 x (24bit / 192kHz balanced)
for connection with CD Box RS2 T using supplied HDMI cable
16.9344 MHz for CD Box RS2 T
2 x ESS9038Q2M 32-bit (dual mono)
8x digital filter
discrete and balanced, tube and solid state
4 x 6922EH
3,5" TFT module, 480x320, 360 cd/m2, contrast ratio
700, IPS technology
1 x RCA
2 x 2,5mm 2-pole (1 x Trigger In, 1x Trigger Out)
max. 1A DC, <0,5W in standby
1520 g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Pro-Ject Audio Systems · Pro-Ject DAC Box RS2 · Revision 2020.02.05
7